This European Standard specifies all the information necessary to facilitate the exchange of data and control information over the power line medium for networked control systems in commercial Building Automation, Controls and Building Management.<\/p>\n
This European Standard establishes a minimal set of rules for compliance. It does not rule out extended services to be provided, given that the rules are adhered to within the system. It is the intention of the standard to permit extended services (defined by users) to coexist.<\/p>\n
Certain aspects of this standard are defined in other documents. These documents are referenced where relevant. In the case where a referenced standard conflicts with this European Standard, this part of EN 14908 will prevail.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 5<\/td>\n | Foreword <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | Introduction Figure 1 \u2014 Relationship of CNP 3 specification to the CNP 1 specification <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | 1 Scope 2 Normative references 3 Terms and definitions <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 4 General description 4.1 Electrical safety 4.2 Functional partitioning of PL specification 5 Power Line Medium specifications 5.1 Power 5.2 Data channel <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | 5.3 Physical and electrical specifications 5.4 Connectors and coupling 5.5 Signal coupling between phases 5.6 Surge protection and related devices 6 PL Node specifications 6.1 Compliance 6.2 Interface to MAC sub-layer <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | Figure 2 \u2014 Power line packet format 6.3 Word encoding Figure 3 \u2014 11-bit word format 6.4 PL packet timing Table 1 \u2014 Transceiver timing specifications 6.5 Transmitter characteristics 6.5.1 Carrier modulation 6.5.2 Waveform amplitude <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | Figure 4 \u2014 Test circuit for determining transmit amplitude 6.5.3 Device coupling 6.5.4 Single phase coupling 6.5.5 Multiple phase coupling <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | 6.6 Receiver characteristics 6.6.1 Receive mode effective input impedance Figure 5 \u2014 Test circuit for determining effective receiver impedance <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | 6.6.2 Receiver performance Figure 6 \u2014 Test circuit for receiver performance 6.6.3 Receiving on a quiet line <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | 6.6.4 Receiving with interference Figure 7 \u2014 Graph of tone interference specification <\/td>\n<\/tr>\n | ||||||
| 15<\/td>\n | Table 2 \u2014 Settings for receive performance with interfering tone test 6.6.5 Receiving through a distorted channel 6.6.6 Receiving with impulsive noise <\/td>\n<\/tr>\n | ||||||
| 17<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Open Data Communication in Building Automation, Controls and Building Management. Control Network Protocol – Power Line Channel Specification<\/b><\/p>\n |