ASTM-D6782 2005

$58.50

D6782-05 Standard Test Methods for Standardization and Calibration of In-Line Dry Lumber Moisture Meters

Published By	Publication Date	Number of Pages
ASTM	2005	22

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 These test methods apply to instruments designed to detect, or measure, moisture in wood which has been dried below the fiber saturation point. The purpose of these tests is to provide a unified standard against which such systems can demonstrate their suitability for their intended use (see Appendix X1).

1.2 The standard is configured to support tests by moisture meter manufacturers as well as end-users of such systems, therefore the text follows two tracks (see Appendix X2).

1.3 Test methods specified for manufacturers are generally designed for laboratory settings and are intended to provide a standard against which a manufacturer certifies calibration and general system conformance.

1.4 Test methods for end-users are generally designed for field settings and are intended as a standardized set of procedures for determining the suitability of a specific machine for a particular use.

1.5 Applications such as lumber marking or sorting systems utilizing the output of the in-line meter are not part of this standard.

1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Significance and Use Laboratory Standardization and Calibration
5	Field Standardization and Evaluation
8	Precision and Bias Keywords X1. COMMENTARY
11	X2. FLOW CHART FOR IN-LINE METERS STANDARDIZATION AND CALIBRATION
12	X3. SENSING PRINCIPLES X3.1 FIG. X2.1
13	X4. STANDARDIZATION AND CALIBRATION X4.1 X4.2 X4.3 X5. MOISTURE CONTENT DISTRIBUTIONS ADDRESSED WITHIN THE STANDARD X5.1 X5.2
14	X6. AIR GAP COMPENSATION X6.1 X6.2 X6.3 X6.4 X7. ANALYSIS OF IN-LINE MOISTURE METER PERFORMANCE UNDER DYNAMIC CONDITIONS X7.1 X7.2
16	X7.3
18	X7.4 X7.5
19	X8. THE CHARACTERISTICS, MEASUREMENT AND ACCEPTANCE OF WET-SPOTS X8.1 X8.2 X8.3 X8.4 X8.5
20	X8.6 X9. SELECTION OF SPECIMENS AND EVALUATION OF ACCEPT/REJECT METERS X9.1 X9.2 X9.3 X9.4 TABLE X9.1
21	X9.5 TABLE X9.2

Additional information

Standard Title	D6782-05 Standard Test Methods for Standardization and Calibration of In-Line Dry Lumber Moisture Meters
Published Code	ASTM
Publication Date	2005
Pages Count	22

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D6782 2005

PDF Catalog

Related products