ASTM-D5948 2020

$37.38

D5948-05(2020) Standard Specification for Molding Compounds, Thermosetting

Published By	Publication Date	Number of Pages
ASTM	2020

Guaranteed Safe Checkout

Categories: 83.040.01 - Raw materials for rubber and plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5948-05-Reapproved2020

Active Standard: Standard Specification for Molding Compounds, Thermosetting

ASTM D5948

Scope

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 Classification—Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1 – Annex A8).

Note 1: There is no known ISO equivalent to this standard.

1.3 Order of Precedence—In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

diallyl phthalate plastics; epoxy plastics; melamine-formaldehyde plastics; molding compounds; phenolic plastics; plastics; polyester plastics; silicone resin molding compounds;

ICS Code

ICS Number Code 83.040.01 (Raw materials for rubber and plastics in general)

DOI: 10.1520/D5948-05R20

Additional information

Standard Title	D5948-05(2020) Standard Specification for Molding Compounds, Thermosetting
Published Code	ASTM
Publication Date	2020
ICS Codes	83.040.01 - Raw materials for rubber and plastics in general