ASTM-D5099 2008

$40.63

D5099-08 Standard Test Methods for Rubber—Measurement of Processing Properties Using Capillary Rheometry

Published By	Publication Date	Number of Pages
ASTM	2008	8

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5099-08

Historical Standard: Standard Test Methods for Rubber—Measurement of Processing Properties Using Capillary Rheometry

ASTM D5099

Scope

1.1 These test methods describe how capillary rheometry may be used to measure the rheological characteristics of rubber (raw or compounded). Two methods are addressed: Method A—using a piston type capillary rheometer, and Method B—using a screw extrusion type capillary rheometer. The two methods have important differences, as outlined in 7-10 and 11-14, respectively.

1.2 These test methods cover the use of a capillary rheometer for the measurement of the flow properties of thermoplastic elastomers, unvulcanized rubber, and rubber compounds. These material properties are related to factory processing.

1.3 Since piston type capillary rheometers impart only a small amount of shearing energy to the sample, these measurements directly relate to the state of the compound at the time of sampling. Piston type capillary rheometer measurements will usually differ from measurements with a screw extrusion type rheometer, which imparts shearing energy just before the rheological measurement.

1.4 Capillary rheometer measurements for plastics are described in Test Method D 3835.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

capillary rheometer; flow properties; piston; processing properties; screw extrusion; shear rate; shear stress; viscosity; Capillary rheometer method; Flow and flow rate–rubber; Piston capillary rheometer; Process control; Raw rubber; Rheology/rheological properties–rubber; Rheometers; Rubber; Screw extrusion

ICS Code

ICS Number Code 83.060 (Rubber)

DOI: 10.1520/D5099-08

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
3	Significance and Use Interferences Sampling and Conditioning of Samples Summary of Test Method TABLE 1
4	Apparatus FIG. 1 FIG. 2
5	Procedure Calculation TABLE 2
6	Summary of Test Method
7	Apparatus Extrusion Procedure FIG. 3 TABLE 3
8	Calculation Report Precision and Bias Keywords

Additional information

Standard Title	D5099-08 Standard Test Methods for Rubber—Measurement of Processing Properties Using Capillary Rheometry
Published Code	ASTM
Publication Date	2008
Pages Count	8