Shopping Cart

No products in the cart.

ASTM-D3464 2001

$35.75

D3464-96(2001) Standard Test Method for Average Velocity in a Duct Using a Thermal Anemometer

Published By Publication Date Number of Pages
ASTM 2001 4
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method describes the measurement of the average velocity with a thermal anemometer for the purpose of determining gas flow in a stack, duct, or flue (1-5) . It is limited to those applications where the gas is essentially air at ambient conditions and the temperature, moisture, and contaminant loading are insignificant as sources of error compared to the basic accuracy of the typical field situation.

1.2 The range of the test method is from 1 to 30 m/s (3 to 100 ft/s).

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
Significance and Use
Apparatus
2 Calibration
Single-Point Velocity Measurement
Average Velocity Measurements
FIG. 1
3 Set-up Procedures
Precision and Bias
Keywords
TABLE 1
FIG. 2
TABLE 2
4 REFERENCES
ASTM-D3464 2001
$35.75