šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-D1316:2011 Edition

ASTM-D1316:2011 Edition

$40.63

D1316-06(2011) Standard Test Method for Fineness of Grind of Printing Inks By the NPIRI Grindometer

Published By Publication Date Number of Pages
ASTM 2011 7
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This test method describes the procedure for determining the fineness of grind of printing inks using a NPIRI Grindometer. It evaluates the size of the largest particles in a finished dispersion but not average particle size or concentration of sizes.

1.2 This test method covers both manual and automatic drawdowns using an A1 scraper.

1.3 This test method is applicable to any dispersion that is fine enough to fall within the 0 25 ? m range of the specified grind gauge. With a minor variation in procedure, it is applicable to both paste (nonvolatile) and liquid (volatile) inks.

Note 1The 0 25 ? m gauge specified in this test method is similar in principle to the 0 100 ? m Hegman gauge described in Test Method D1210 and the various gauges described in ISO 1524:2000. Sieve analysis for concentration of particles above 45 ? m is covered in Test Method D2067 .

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
Significance and Use
2 Apparatus
FIG. 1
FIG. 2
FIG. 3
TABLE 1
3 Materials
Care of Gauge and Blade
Sampling
Procedure for Manual Drawdowns
FIG. 4
4 Procedure for Automatic Drawdowns Using ADM-1
Reading of Endpoints and Report
FIG. 5
FIG. 6
5 Precision and Bias
TABLE 2
TABLE 3
TABLE 4
6 Keywords

Related products

ASTM-D1316
$40.63