ASTM-D1044:2013 Edition

$40.63

D1044-13 Standard Test Method for Resistance of Transparent Plastics to Surface Abrasion

Published By	Publication Date	Number of Pages
ASTM	2013	8

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D1044-13

Historical Standard: Standard Test Method for Resistance of Transparent Plastics to Surface Abrasion

ASTM D1044

Scope

1.1 This test method describes a procedure for estimating the resistance of transparent plastics to one kind of surface abrasion by measuring the change in optical properties.

1.2 Abrasive damage is visually judged and numerically quantified by calculating the difference in haze percentage in accordance with Test Method D1003 between an abraded and unabraded specimen.

1.3 CS-10F wheels manufactured between October 2002 and September 2004 have been found to give different results than historical values. Comparisons of data using these wheels should be made with caution. Results using wheels made after September 2004 have agreed with those obtained before October 2002.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

Note 1—This test method is equivalent in the measurement of resistance to abrasion of ISO 3537, Section 7 and ISO 15082, Section 11, but is not equivalent in any other measurement or section. This test method is not equivalent to ISO 9352, and results cannot be directly compared between the two methods.

Note 2—This test method is similar to ANSI/SAE Z26.1, Test 17.

Note 3—Prior attempts to employ the Taber Abraser for volume loss determinations of various plastics² have been unsuccessful because of excessively large coefficients of variation attributed to the data. Insufficient agreement among the participating laboratories has rendered the use of volume loss procedure inadvisable as an ASTM test method.

Note 4—For determining the resistance to abrasion of organic coatings by weight loss, reference is made to Test Method D4060, which uses more aggressive CS-10 or CS-17 abrasive wheels.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

abrasion; haze; hazemeter; surface abrasion; Taber abraser

ICS Code

ICS Number Code 83.080.01 (Plastics in general)

DOI: 10.1520/D1044-13

Additional information

Standard Title	D1044-13 Standard Test Method for Resistance of Transparent Plastics to Surface Abrasion
Published Code	ASTM
Publication Date	2013
Pages Count	8
ICS Codes	83.080.01 - Plastics in general