Shopping Cart

No products in the cart.

ASTM-C1166:2021 Edition(Redline)

$35.75

C1166-21 Standard Test Method for Flame Propagation of Dense and Cellular Elastomeric Gaskets and Accessories (Redline)

Published By Publication Date Number of Pages
ASTM 2021 4
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM C1166-21

Redline Standard: Standard Test Method for Flame Propagation of Dense and Cellular Elastomeric Gaskets and Accessories

ASTM C1166

Scope

1.1 This test method covers a laboratory procedure for determining flame propagation characteristics of a dense or cellular elastomeric gasket (such as expansion, lock-strip or compression gasket) or an accessory (such as a setting block, spacer or shim) when exposed to heat and flame, with no significance being attached to such matters as fuel contribution, rate of flame spread, smoke developed, or the nature and temperature of the products of combustion.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.3 This standard should be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire-hazard or fire-risk of materials, products, or assemblies under actual fire conditions. However, results of the test may be used as elements of a fire-hazard assessment or a fire-risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

elastomer; flame propagation; flammability; gasket;

ICS Code

ICS Number Code 21.140 (Seals, glands)

DOI: 10.1520/C1166-21

ASTM-C1166
$35.75