ASTM-A249 2008

$40.63

A249/A249M-08 Standard Specification for Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes

Published By	Publication Date	Number of Pages
ASTM	2008	10

Guaranteed Safe Checkout

Categories: 23.040.10 - Iron and steel pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers nominal-wall-thickness welded tubes and heavily cold worked welded tubes made from the austenitic steels listed in Table 1, with various grades intended for such use as boiler, superheater, heat exchanger, or condenser tubes.

1.2 Grades TP304H, TP309H, TP309HCb, TP310H, TP310HCb, TP316H, TP321H, TP347H, and TP348H are modifications of Grades TP304, TP309S, TP309Cb, TP310S, TP310Cb, TP316, TP321, TP347, and TP348, and are intended for high-temperature service such as for superheaters and reheaters.

1.3 The tubing sizes and thicknesses usually furnished to this specification are ¹ / ₈ in. [3.2 mm] in inside diameter to 12 in. [304.8 mm] in outside diameter and 0.015 to 0.320 in. [0.4 to 8.1 mm], inclusive, in wall thickness. Tubing having other dimensions may be furnished, provided such tubes comply with all other requirements of this specification.

1.4 Mechanical property requirements do not apply to tubing smaller than ¹ / ₈ in. [3.2 mm] in inside diameter or 0.015 in. [0.4 mm] in thickness.

1.5 Optional supplementary requirements are provided and, when one or more of these are desired, each shall be so stated in the order.

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the M designation of this specification is specified in the order.

1.7 The following safety hazards caveat pertains only to the test method described in the Supplementary Requirements of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in Supplementary Requirement S7, Note S7.1.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Ordering Information General Requirements Manufacture
3	TABLE 1
6	Heat Treatment Chemical Composition Product Analysis TABLE 2
7	Tensile Requirements Hardness Requirements Reverse-Bend Test Requirement Grain Size Requirement Mechanical Tests and Grain Size Determinations Required TABLE 3 TABLE 4
8	Permissible Variations in Dimensions Workmanship, Finish, and Appearance Surface Condition Forming Operations Product Marking Keywords

Additional information

Standard Title	A249/A249M-08 Standard Specification for Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes
Published Code	ASTM
Publication Date	2008
Pages Count	10
ICS Codes	23.040.10 - Iron and steel pipes

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A249 2008

PDF Catalog

Related products