ESDU 75035:1975
$62.40
Initial Buckling of Square Plates in Shear with Central Flanged Circular Holes
| Published By | Publication Date | Number of Pages |
| ESDU | 1975-11 | 5 |
ESDU 75035 gives graphs as a function of reinforcement height/plate thickness ratio for three values of hole diameter/plate width ratio for the buckling stress as a fraction of that for a plate without a hole (for which ESDU 71005 provides an answer). The data were obtained from finite element calculations for holes with symmetrical reinforcement together with experimental results from tests made on panels with flanged holes. The experimental data show that predictions made using the curves are in adequate agreement for diameter/plate thickness ratios exceeding 100, but that disagreement exists at lower values.
Related products
-
ESDU 75005:1976
Performance data for the critical operation of nominally two-dimensional double-ramp supersonic intakes Published By Publication…
-
ESDU 75033:1975
Elastic Stress Concentration Factors. Double Radius Fillets in Shouldered Shafts in Torsion Published By Publication…
-
ESDU 75034:1975
Initial Buckling Stress, Maximum Direct Stress and Shear Strain of Square Plates in Shear with…
-
ESDU 75030:1995
Natural Frequencies of Rectangular Flat Plates with Various Edge Conditions Published By Publication Date Number…
-
ESDU 78035:1995
Contact Phenomena – I: Stresses, Deflections and Contact Dimensions for Normally-Loaded Unlubricated Elastic Components Published…