ASTM-D774/D774M 2007
$35.75
D774/D774M-97(2007) Standard Test Method for Bursting Strength of Paper (Withdrawn 2010)
| Published By | Publication Date | Number of Pages |
| ASTM | 2007 | 4 |
ASTM D774/D774M-97-Reapproved2007
Withdrawn Standard: Standard Test Method for Bursting Strength of Paper (Withdrawn 2010)
ASTM D774/D774M
Scope
1.1 This test method covers measurements of the bursting strength of paper and paper products occurring as single or laminated flat sheets not over 0.6 mm [0.025 in.] in thickness having a bursting strength of 30 kPa up to 1400 kPa [4 psi up to 200 psi].
1.2 This test method is not intended for use in testing corrugated boxboard, liner board, or hardboards that tend to cut the thin rubber diaphragm.
Note 1—Similar procedures for making bursting strength measurements are found in ISO 2758 and TAPPI 403.
1.3 The values stated in either SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bursting strength; Mullen test; paper; paper products
ICS Code
ICS Number Code 85.060 (Paper and board)
DOI: 10.1520/D0774_D0774M-97R07
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Significance and Use Apparatus |
| 2 | Sampling Test Specimens Calibration and Maintenance TABLE 1 |
| 3 | Conditioning Procedure Calculation Report Precision and Bias TABLE 2 |
| 4 | Keywords REFERENCES |
