This part of IEC 60684 gives the requirements for two types of general purpose, flexible, flame retarded, heat-shrinkable polyolefin sleeving. This sleeving has been found suitable for use at temperatures up to 125 \u00b0C.<\/p>\n
Type A \u2013 Highly flame retarded<\/p>\n<\/li>\n
Type B \u2013 Flame retarded<\/p>\n<\/li>\n<\/ul>\n
The minimum supplied and maximum recovered internal diameters shall be specified by the manufacturer and shall meet the minimum wall thicknesses given in Table 2.<\/p>\n
It is normally available in bore sizes up to 75 mm as supplied and in the following colours: black, brown, white, red, yellow, green, blue, orange, violet, grey and yellow\/green.<\/p>\n
Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 6<\/td>\n | English CONTENTS <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | INTRODUCTION <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 1 Scope 2 Normative references 3 Designation <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | 4 Conditions of test 5 Requirements 6 Sleeving conformance Table 1 \u2013 Required test samples Table 2 \u2013 Minimum recovered wall thicknesses for maximum recovered internal diameters <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | Table 3 \u2013 Property requirements <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | Table 4 \u2013 Mandrel diameters for heat shock and low temperature bending <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Flexible insulating sleeving – Specifications for individual types of sleeving. Heat-shrinkable polyolefin sleeving, general purpose, flame retarded<\/b><\/p>\n |