1.1 This practice covers the standards and procedures for the pulse-echo ultrasonic examination of heat-treated carbon, low-alloy, and martensitic stainless steel castings by the longitudinal-beam technique.<\/p>\n
1.2 This practice is to be used whenever the inquiry, contract, order, or specification states that castings are to be subjected to ultrasonic examination in accordance with Practice A 609\/A 609M.<\/p>\n
1.3 This practice contains two procedures for ultrasonic inspection of carbon, low-alloy, and martensitic stainless steel castings; that is, Procedure A and Procedure B. Procedure A is the original A 609\/A 609M practice and requires calibration using a series of test blocks containing flat bottomed holes. It also provides supplementary requirements for angle beam testing. Procedure B requires calibration using a back wall reflection from a series of solid calibration blocks.<\/p>\n
Note 1-Ultrasonic examination and radiography are not directly comparable. This examination technique is intended to complement Guide E 94 in the detection of discontinuities.<\/p>\n
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.<\/p>\n
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 1<\/td>\n | Scope Referenced Documents Ordering Information <\/td>\n<\/tr>\n | ||||||
| 2<\/td>\n | Apparatus Personnel Requirements FIG. 1 TABLE 1 <\/td>\n<\/tr>\n | ||||||
| 3<\/td>\n | Casting Conditions Test Conditions Procedure FIG. 2 <\/td>\n<\/tr>\n | ||||||
| 4<\/td>\n | Report Acceptance Standards Apparatus TABLE 2 <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Ultrasonic Instrument Qualification Preparation FIG. 3 TABLE 3 <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | Calibration Scanning Additional Transducer Evaluation TABLE 4 <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Acceptance Criteria Records Product Marking Keywords <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | FIG. S1.1 <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | TABLE S1.1 <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" A609\/A609M-91(2007) Standard Practice for Castings, Carbon, Low-Alloy, and Martensitic Stainless Steel, Ultrasonic Examination Thereof<\/b><\/p>\n |