IEEE 1017.1-2021(Redline)

$65.00

IEEE Recommended Practice for Testing of Electric Submersible Pump Cable (Redline)

Published By	Publication Date	Number of Pages
IEEE	2021

Guaranteed Safe Checkout

Category: IEEE

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Revision Standard – Active. Procedures and test voltage values for factory, acceptance, and maintenance testing of electric submersible pump (ESP) cable systems are presented. This recommended practice applies to cable systems rated 3 kV through 8 kV (phase to phase) and is intended only for this special purpose cable. The intent is to provide uniform test procedures and guidelines for evaluation of the test results.

PDF Catalog

PDF Pages	PDF Title
1	IEEE Std 1017.1-2021 Front cover
2	Title page
4	Important Notices and Disclaimers Concerning IEEE Standards Documents
7	Participants
8	Introduction
10	Contents
12	1. Overview 1.1 Background
13	1.2 Scope 1.3 Purpose 1.4 Word usage 2. Normative references
14	3. Definitions, acronyms, and abbreviations 3.1 Definitions
16	3.2 Acronyms and abbreviations
18	4. Safety 4.1 Description 4.2 Application 4.3 Procedures to secure cable test area
19	5. General considerations 5.1 Environmental influences 5.2 Cable storage 5.3 Equipment maintenance
20	5.4 Tests covered by the recommended practice 5.5 Additional test equipment
21	6. DC hi-pot test methods 6.1 Overview
22	6.2 Precautions 6.3 DC high potential tester (hi-pot) 6.4 Equipment setup
23	6.5 Procedures
25	6.6 Evaluation of dc hi-pot test results
33	7. Conductor resistance and continuity tests
34	8. Finished armored cable factory tests 8.1 DC withstand test
35	8.2 AC withstand test 8.3 DC test conductance leakage readings 9. Mechanical integrity of armored cable 10. Mechanical/chemical testing of nonlead metallic barrier cables with encapsulating jacket 10.1 Cold bend
36	10.2 Abrasion resistance
37	10.3 Tear resistance
39	11. Effect of chemical exposure on tensile, yield, and elongation 11.1 Purpose 11.2 Test specimen 11.3 Alternative test specimen 11.4 Chemical exposure conditions
42	11.5 Chemical compatibility with well fluids (optional) 11.6 Cold impact test 11.7 Stripability/removal 12. Partial discharge (PD) testing 12.1 Overview
43	12.2 Precautions 12.3 Procedures
45	12.4 Interpretation of results
46	13. Very low frequency/tan-delta (VLF/TD) testing 13.1 Overview 13.2 Precautions 13.3 VLF/Tan-delta test equipment
47	13.4 Equipment setup 13.5 Procedures
48	13.6 Evaluation of VLF-TD results
57	14. Testing of surface feedthroughs and connections 14.1 Description 14.2 Environment
59	14.3 Wellhead with pack-off (no connections at wellhead) 14.4 Wellhead with connections
60	14.5 Visual Inspection
61	14.6 Procedure for testing of potheads (motor connectors)
62	14.7 Testing of wellhead penetrators
65	Annex A (informative) Bibliography