BS ISO 6518-2:2024
$142.49
Road vehicles. Ignition systems – Electrical performance and function test methods
| Published By | Publication Date | Number of Pages |
| BSI | 2024 | 30 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | undefined |
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions 4 Ignition system description |
| 10 | 5 System load 6 Ignition parameter measurements 6.1 Available secondary (spark) voltage |
| 11 | 6.2 Secondary output voltage (open circuit coil secondary voltage) 6.3 Minimum available voltage (loaded secondary voltage) |
| 12 | 6.4 Secondary voltage at primary current switch on (feed forward voltage) |
| 13 | 6.5 Zener discharge current (peak spark current) |
| 14 | 6.6 Zener discharge duration 6.7 Zener discharge voltage |
| 15 | 6.8 Zener discharge energy |
| 16 | 6.9 Primary current (peak coil current) |
| 17 | 6.10 Average current input 6.11 Primary energy |
| 18 | 6.12 Coil secondary voltage risetime 6.13 Peak coil primary voltage |
| 19 | 6.14 Spark timing delay (time lag/delay time) |
| 20 | 6.15 Dwell time or dwell angle |
| 21 | 7 Test equipment 7.1 Voltage probe (voltage divider) 7.2 Oscilloscope 7.3 Current probe |
| 22 | 7.4 DC source 7.5 Signal generator (arbitrary waveform generator) 7.6 Secondary loading 7.7 Test bench setup |
| 23 | 8 Test procedures for ignition system parameter measurements 8.1 General comments |
| 24 | 8.2 Secondary voltage measurements |
| 25 | 8.3 Secondary spark energy measurements |
| 26 | 8.4 Miscellaneous measurements |
| 27 | 9 Test procedures for ignition system parameter measurements |
