BS ISO 6361-4:2014
$102.76
Wrought aluminium and aluminium alloys. Sheets, strips and plates – Sheets and plates: Tolerances on shape and dimensions
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
This part of ISO 6361 specifies the tolerances on shape and dimensions for wrought aluminium and aluminium alloy sheet and plate by hot-rolling or cold-rolling for general engineering applications.
It applies to products with a thickness over 0,15 mm up to and including 203 mm.
It does not apply to semi-finished rolled products in coiled form to be subjected to further rolling (reroll stock) or to special products, such as those that are corrugated or embossed.
Technical conditions for inspection and delivery of products covered by this part of ISO 6361 are specified in ISO 6361-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Table tab_1 1 Scope 2 Normative references 3 Dimensional tolerances 3.1 Thickness |
| 8 | Table tab_2 |
| 9 | Table tab_3 |
| 10 | Table tab_4 |
| 11 | Section sec_3.2 Table tab_5 3.2 Width |
| 12 | Table tab_6 Section sec_3.3 Table tab_7 Table tab_8 3.3 Length |
| 13 | Section sec_4 Section sec_4.1 Table tab_a Figure fig_1 Table tab_9 Section sec_4.2 4 Shape tolerances 4.1 Lateral curvature 4.2 Flatness tolerances |
| 14 | Table tab_10 Table tab_b Figure fig_2 |
| 15 | Table tab_c Figure fig_3 Table tab_d Figure fig_4 |
| 16 | Table tab_e Figure fig_5 Section sec_4.3 Table tab_11 4.3 Squareness tolerances |
| 17 | Table tab_f Figure fig_6 |
| 18 | Reference ref_1 Bibliography |
