BS ISO 3302-1:2014
$102.76
Rubber. Tolerances for products – Dimensional tolerances
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
This part of ISO 3302 specifies classes of dimensional tolerances and their values for moulded, extruded, and calendared solid rubber products. The relevant test methods necessary for the establishment of compliance with this part of ISO 3302 are also specified.
The tolerances are primarily intended for use with vulcanized rubber but can also be suitable for products made of thermoplastic rubbers.
This part of ISO 3302 does not apply to precision toroidal sealing rings or to calendared composite products such as rubber-coated fabrics or products where a rubber coating is applied by the process of topping or skim coating.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 1 Scope 2 Normative references 3 Measurement of dimensions 3.1 General |
| 10 | Section sec_3.2 Section sec_3.2.1 Section sec_3.2.1.1 Section sec_3.2.1.2 Section sec_3.2.1.3 Section sec_3.2.1.4 Section sec_3.2.2 Section sec_3.2.3 Section sec_4 Section sec_5 Section sec_5.1 3.2 Test instruments 4 Tolerances 5 Mouldings 5.1 General |
| 11 | Section sec_5.2 Section sec_5.3 Section sec_5.3.1 Section sec_5.3.2 Section sec_5.4 5.2 Classification 5.3 Fixed dimensions and closure dimensions 5.4 Tolerances |
| 12 | Table tab_a Figure fig_1 |
| 13 | Table tab_1 Section sec_5.5 Table tab_2 Section sec_6 Section sec_6.1 5.5 Flash 6 Extrusions 6.1 General |
| 14 | Section sec_6.2 Section sec_6.3 Section sec_6.3.1 Section sec_6.3.2 6.2 Classification 6.3 Tolerances |
| 15 | Table tab_3 Section sec_6.3.3 Table tab_4 |
| 16 | Section sec_6.3.4 Section sec_6.3.4.1 Table tab_5 Section sec_6.3.4.2 Table tab_6 Section sec_6.3.5 |
| 17 | Table tab_7 Section sec_6.3.6 Table tab_8 Section sec_7 Section sec_7.1 7 Calendered sheet 7.1 General |
| 18 | Section sec_7.2 Section sec_7.3 Table tab_9 Table tab_10 7.2 Classification 7.3 Tolerances |
