BS ISO 26910-1:2009+A1:2017
$102.76
Springs. Shot peening – General procedures
| Published By | Publication Date | Number of Pages |
| BSI | 2017 | 22 |
This document specifies general requirements for the shot peening process applied to springs in order to improve their resistance to fatigue and stress corrosion cracking, mainly by introducing compressive residual stresses into their surface layers.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 2 | National foreword |
| 6 | Foreword |
| 7 | 1 Scope 2 Normative references 3 Terms and definitions |
| 9 | 4 Strategies for conducting shot peening 4.1 General 4.2 Mode of shot peening 4.3 Conditions of shot peening |
| 10 | 4.4 Category of shot peening machine 4.5 Protection of non-peening surface 4.6 Pre- and post-peening treatments 5 Peening media 6 Almen strip 6.1 Class of Almen strip |
| 11 | 6.2 Selection of the class of Almen strip 6.3 Almen strip holder |
| 12 | 7 Method of measurement 7.1 Measurement of Almen arc height |
| 13 | 7.2 Evaluation of coverage 7.3 Determination of saturation time |
| 14 | 8 Shot peening machine 9 Control of shot peening 9.1 Almen arc height 9.2 Coverage 10 Measurement of residual stress 11 Report |
| 15 | Annex A (normative) Standard photographs of coverage |
| 16 | Annex B (normative) Saturation time |
| 18 | Annex C (informative) Almen gauge |
| 20 | Bibliography |
