BS EN ISO 16841:2014
$102.76
Steel wire ropes. Pulling eyes for rope installation. Types and minimum requirements
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
This International Standard identifies the different types of pulling eyes prepared at, or attached to, a steel wire rope end for connection to another rope when installing a new rope or re-reeving an existing rope on a machine.
This International Standard also specifies the minimum requirements for pulling eyes, including their geometry, strength, maximum line pull to which the pulling eye is intended to be subjected and information for use to be provided by the manufacturer.
The pulling eyes covered by this International Standard are not intended to be subjected to a load when the machine performs a service operation.
This International Standard applies to those pulling eyes prepared at, or attached to, ends of steel wire ropes conforming to ISO 2408 and ISO 10425.
This International Standard does not apply to steel wire ropes with fibre cores.
This International Standard does not cover those separate end connection accessories, which slide over the end of a rope and comprise an eye- and tubular-type braided rope, often referred to as a “wire rope stocking” or “cable sock”.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 Section sec_3.2 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | Section sec_3.3 Section sec_3.4 Section sec_3.5 Section sec_3.6 Section sec_4 Section sec_4.1 4 Requirements 4.1 General |
| 11 | Section sec_4.2 Section sec_4.2.1 Figure fig_1 Section sec_4.2.2 Figure fig_2 4.2 Geometry |
| 12 | Section sec_4.2.3 Figure fig_3 Section sec_4.2.4 |
| 13 | Figure fig_4 Figure fig_5 Section sec_4.2.5 |
| 14 | Figure fig_6 Section sec_4.3 Section sec_4.3.1 Section sec_4.3.2 Section sec_4.3.3 4.3 Type testing |
| 15 | Section sec_4.4 Section sec_4.5 Section sec_5 Section sec_5.1 4.4 Pulling eye working load limit (WLL) 4.5 Welder qualification for rigid-type pulling eyes 5 Verification of the requirements 5.1 Tensile test |
| 16 | Section sec_5.2 Section sec_6 Section sec_6.1 Section sec_6.2 5.2 Durability test 6 Information for use 6.1 Marking 6.2 Certificate of compliance |
| 17 | Annex sec_A Annex A (informative) Determination of the line pull to which the pulling eye is subjected during installation or a re-reeving operation |
| 18 | Reference ref_1 Reference ref_2 Reference ref_3 Bibliography |
