BS EN ISO 13927:2015
$142.49
Plastics. Simple heat release test using a conical radiant heater and a thermopile detector
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 32 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | Foreword |
| 7 | Foreword |
| 8 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 10 | 4 Symbols 5 Principle 6 Apparatus 6.1 General |
| 12 | 6.2 Cone-shaped radiant electrical heater 6.3 Heat flux controller |
| 13 | 6.4 Thermopile and housing 6.5 Specimen holder |
| 15 | 6.6 Fume extraction system 6.7 Ignition circuit |
| 16 | 6.8 Ignition timer 6.9 Heat flux meter 6.10 Calibration burner 6.11 Data collection system |
| 18 | 7 Suitability of a product for testing 7.1 Surface characteristics 7.2 Asymmetrical products 7.3 Thin materials 7.4 Composite specimens 7.5 Dimensionally unstable materials |
| 19 | 7.6 Materials that require testing under compression 8 Specimen construction and preparation 8.1 Specimens |
| 20 | 8.2 Conditioning of specimens 8.3 Preparation 8.3.1 Specimen wrapping |
| 21 | 8.3.2 Specimen preparation 8.3.3 Preparing specimens of materials that require testing under compression 9 Calibration 9.1 Heater calibration |
| 22 | 9.2 Thermopile calibration 9.2.1 General 9.2.2 Initial calibration 9.2.3 Daily calibration 10 Test procedure |
| 23 | 10.1 Initial preparation 10.2 Procedure |
| 24 | 11 Precision 12 Test report |
| 25 | Annex A (normative) Calibration of the heat flux meter |
| 26 | Annex B (informative) Guidance notes for operators |
| 27 | Annex C (informative) Measuring mass loss during testing |
| 28 | Annex D (informative) Calculation of effective critical heat flux for ignition |
| 29 | Bibliography |
