AWWA C200 2005

$75.83

AWWA C200-05: Steel Water Pipe 6 Inch (150 MM) & Larger

Published By	Publication Date	Number of Pages
AWWA	2005	44

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard covers electrically butt-welded, straight seam or spiral seam steel pipe, 6 in. (150 mm) and larger, for transmission and distribution of water, including fabrication of pipe, requirements of welding operations, permissible variations of weight and dimensions, preparation of ends, fabrication of specials, inspection, and test procedures.

PDF Catalog

PDF Pages	PDF Title
1	AWWA C200-05
3	Committee Personnel
7	Contents
9	Foreword I. Introduction.
11	II. Special Issues.
13	III. Use of This Standard.
15	IV. Major Revisions. V. Comments.
17	AWWA Standard Steel Water Pipe-6 In. (150 mm) and Larger SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
18	SECTION 2: REFERENCES
20	SECTION 3: DEFINITIONS
23	SECTION 4: REQUIREMENTS Sec. 4.1 Permeation
24	Sec. 4.2 Materials and Workmanship Sec. 4.3 Drawings
25	Sec. 4.4 Calculations Sec. 4.5 Protective Coating Sec. 4.6 Pipe Made to ASTM Requirements Sec. 4.7 Fabricated Pipe
26	Table 1 Steel plate, sheet, or coils for fabricated pipe
27	Sec. 4.8 Selection of Materials Sec. 4.9 General Requirements for Fabrication of Pipe Sec. 4.10 Fabrication of Pipe
28	Sec. 4.11 Requirements for Welding Operations
31	Table 2 Guided-bend test jig dimensions
33	Sec. 4.12 Permissible Variations in Weights and Dimensions
34	Sec. 4.13 Preparation of Ends
38	Sec. 4.14 Special Ends Sec. 4.15 Specials and Fittings
39	Sec. 4.16 Fabrication of Specials SECTION 5: VERIFICATION Sec. 5.1 Inspection
40	Sec. 5.2 Test Procedures
42	Sec. 5.3 Calibration of Equipment SECTION 6: DELIVERY Sec. 6.1 Marking
43	Sec. 6.2 Handling and Loading Sec. 6.3 Affidavit of Compliance