ASTM-G99 2010

$40.63

G99-05(2010) Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus

Published By	Publication Date	Number of Pages
ASTM	2010	5

Guaranteed Safe Checkout

Categories: 17.040.20 - Properties of surfaces, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Summary of Test Method
2	Significance and Use TABLE 1 TABLE 2
3	Apparatus Test Specimens and Sample Preparation Test Parameters Procedure FIG. 1
4	Calculation and Reporting Precision and Bias
5	Keywords X1. EQUATIONS X1.1

Additional information

Standard Title	G99-05(2010) Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
Published Code	ASTM
Publication Date	2010
Pages Count	5
ICS Codes	17.040.20 - Properties of surfaces

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-G99 2010

PDF Catalog

Related products