ASTM-F708 1997

ASTM F708

Scope

1.1 This practice covers acceptable methods of fabricating and installing rigid pipe hangers used to support shipboard piping systems with temperatures of 650°F (343°C) or less.

1.2 This practice provides guidance for the design of hanger caps, straps and standoffs, selection of hanger and hanger liner materials, hanger bolting, and hanger spacing.

1.3 Other hanger designs may be used provided they result in an adequately supported vibration free piping system and are compatible with the intended system service and temperature limitations.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Banded-weld stud-type hanger (for shipboard piping); Clamp hanger (for shipboard piping); Hangers (for ship piping); J-band hanger (for shipboard piping); Nelson hanger (for shipboard piping); Split cap hanger (for ships); Stauff twin clamp hanger (for shipboard piping); Steel pipe-shipbuilding piping materials; Strap hanger (for ships); U-bolt hangers/joints (for shipboard piping)

ICS Code

ICS Number Code 21.060.70 (Clamps and staples)

DOI: 10.1520/F0708-92R97