🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-F1498:2000 Edition

ASTM-F1498:2000 Edition

$44.96

F1498-00e1 Standard Specification for Taper Pipe Threads 60° for Thermoplastic Pipe and Fittings

Published By Publication Date Number of Pages
ASTM 2000 12
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM F1498-00e1

Historical Standard: Standard Specification for Taper Pipe Threads 60° for Thermoplastic Pipe and Fittings

ASTM F1498

Scope

1.1 This specification establishes requirements fordimensions and gaging of taper pipe threads used on threaded plastic pipe and fittings.

1.2 Threads meeting this specification shall only be used on those plastic materials deemed suitable by the manufacturer.

1.3 Specialty threads or threads not requiring a leak-tight joint are not covered in this specification. Note 1The terms “wrench makeup” and “wrench tight” are standard terminology for tightness and do not imply using a pipe wrench or other tools which would damage plastic pipe and fittings. The terms “hand-tight” and “hand-tight engagement” refer only to thread gaging (not pipe and fitting connections) and is the definition of the L1 gage length.

1.4 Thread DesignationsThe type of pipe threads included in this specification are designated by specifying in sequence the nominal pipe size, number of threads per inch, and the thread series symbols as follows in accordance with ANSI/ASME B 1.20.1: 3/8-18 NPT. For left-hand threads add LH to the designation, otherwise right-hand threads will be understood. For example: 3/8-18 NPT-LH.

1.4.1 Each of these letters in the symbol has a definite significance as follows:

N = National (American Standard) P = Pipe T = Taper

1.5 The values stated in inch-pound units are to be regarded as the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see and .

Keywords

fitting threads; pipe threads; plastic pipe threads; taper pipe threads; threads

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F1498-00E01

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
American National Standard Taper Pipe Thread Form
2 FIG. 1
3 TABLE 1
TABLE 2
4 TABLE 3
5 Specification for General Purpose Taper Pipe Threads, NPT
TABLE 3
6 TABLE 4
7 TABLE 5
8 Precision of Measurement
Gages and Gage Tolerances for American National Standard Pipe Threads
TABLE 6
9 FIG. 2
FIG. 3
FIG. 4
FIG. 5
10 Gaging Taper Threads
TABLE 7
FIG. 6
FIG. 7
FIG. 8
11 Keywords
FIG. 9

Related products

ASTM-F1498
$44.96