ASTM-E998 2012
$44.96
E998-12 Standard Test Method for Structural Performance of Glass in Windows, Curtain Walls, and Doors Under the Influence of Uniform Static Loads by Nondestructive Method
| Published By | Publication Date | Number of Pages |
| ASTM | 2012 | 17 |
1.1 This test method is a nondestructive test procedure to establish the nature of stresses induced in glass subjected to uniform static loads. A procedure is provided for using this stress information to estimate the probability of breakage of the glass.
1.2 This test method is applicable to glass of various degrees of temper; for example, annealed, heat-strengthened, fully tempered, laminated, insulating, and combinations thereof.
1.3 This test method describes a process of applying specific test loads to glass. The test may be conducted using the standard test frame specified herein or a test frame of the user’s design.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements see Section 7.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Summary of Test Method Significance and Use Apparatus Safety Precautions Sampling and Glass Specimens Calibration Required Information |
| 3 | Procedure Report Analysis Precision and Bias |
| 4 | Keywords A1. STANDARD GLASS TEST FRAME A1.1 Introduction A1.2 Structural Support System A1.3 Glazing System |
| 5 | FIG. A1.1 |
| 6 | FIG. A1.2 |
| 7 | FIG. A1.3 |
| 8 | A2. INSTALLATION OF STRAIN GAGES A2.1 Glass Surface Preparation Safeguards and Cleaning Recommendations FIG. A1.4 |
| 9 | A2.2 Strain Gage Lay-Out Lines Application A2.3 Strain Gage Installation Methods, Techniques, and Tips |
| 10 | X1. STRAIN GAGE TECHNIQUES FOR ANALYSIS OF GLASS LITES X1.1 Introduction X1.2 Apparatus X1.3 Stress Distribution TABLE X1.1 |
| 11 | X1.4 Stress Data Calculations FIG. X1.1 |
| 12 | TABLE X1.2 |
| 13 | FIG. X1.2 |
| 14 | FIG. X1.3 |
| 15 | FIG. X1.4 |
| 16 | TABLE X1.3 TABLE X1.4 |
| 17 | REFERENCES |
Related products
-
ASTM-E998 2012(Redline)
E998-12 Standard Test Method for Structural Performance of Glass in Windows, Curtain Walls, and Doors…
