ASTM-D4097 2001
$44.96
D4097-01 Standard Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
| Published By | Publication Date | Number of Pages |
| ASTM | 2001 | 17 |
ASTM D4097-01
Historical Standard: Standard Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
ASTM D4097
Scope
1.1 This specification covers cylindrical tanks fabricated by contact molding for above-ground vertical installation, to contain aggressive chemicals at essentially atmospheric pressure, and made of a commercial-grade polyester or vinyl ester, resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance.
1.2 This specification does not cover the design of vessels intended for pressure above hydrostatic, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points.
1.3 The values given in parentheses are provided for information purposes only. Note 1Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, to vessels subject to service temperature in excess of 180°F (82°C), and to vessels with unsupported bottoms.
Note 2—There is no similar or equivalent ISO standard.
1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
above ground; atmosphere; contact-molded; polyester; vinylester
ICS Code
ICS Number Code 23.020.10 (Stationary containers and tanks)
DOI: 10.1520/D4097-01
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Classification Materials and Manufacture Design Requirements |
| 3 | FIG. 1 |
| 4 | FIG. 2 |
| 5 | TABLE 1 TABLE 2 |
| 6 | TABLE 3 TABLE 4 |
| 7 | Laminate Construction Requirements FIG. 3 FIG. 4 TABLE 5 |
| 8 | TABLE 6 |
| 9 | FIG. 5 |
| 10 | FIG. 6 |
| 11 | Requirements FIG. 7 |
| 12 | Dimensions and Tolerances Workmanship, Finish, and Appearance Test Methods TABLE 7 |
| 13 | Product Marking FIG. 8 |
| 14 | Packaging and Package Marking Shipping Keywords X1. HANDLING AND INSTALLATION X1.1 Handling X1.2 Installation |
| 15 | X2. WALL THICKNESSES X2.1 TABLE X2.1 |
| 16 | X3. DISHED BOTTOM X3.1 FIG. X3.1 |
