ASTM-D2447 2001

$40.63

D2447-01 Standard Specification for Polyethylene (PE) Plastic Pipe, Schedules 40 and 80, Based on Outside Diameter

Published By	Publication Date	Number of Pages
ASTM	2001	8

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D2447-01

Historical Standard: Standard Specification for Polyethylene (PE) Plastic Pipe, Schedules 40 and 80, Based on Outside Diameter

ASTM D2447

Scope

1.1 This specification covers polyethylene (PE) pipe that is outside diameter controlled, made in Schedule 40 and 80 sizes for use with socket-type fittings and butt fittings joined by heat fusion, and pressure-rated for water (see appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.

1.2 The values stated in inch-pound units are to regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

polyethylene (PE) pipe; schedule 40/80 pipe; polyethylene (PE) plastic pipe (outside diameter controlled), schedules 40/

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/D2447-01

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Pipe Classification Materials Requirements TABLE 1
3	Test Methods TABLE 2
4	TABLE 3 TABLE 4
5	Retest and Rejection Marking TABLE 5
6	Quality Assurance TABLE 6
7	X1. SOURCE OF HYDROSTATIC DESIGN STRESSES X1.1 X1.2 X1.3 X1.4 X1.5
8	TABLE X1.1

Additional information

Standard Title	D2447-01 Standard Specification for Polyethylene (PE) Plastic Pipe, Schedules 40 and 80, Based on Outside Diameter
Published Code	ASTM
Publication Date	2001
Pages Count	8
ICS Codes	23.040.20 - Plastics pipes