ASTM-B955 2008
$44.96
B955/B955M-08 Standard Specification for Aluminum-Alloy Centrifugal Castings
| Published By | Publication Date | Number of Pages |
| ASTM | 2008 | 11 |
1.1 This specification covers aluminum-alloy centrifugal castings designated as shown in Table 1.
1.2 This specification is not intended for aluminum-alloy centrifugal castings used in aerospace applications.
1.3 Alloy and temper designations are in accordance with ANSI H35.1 / H35.1 (M). The equivalent unified numbering system alloy designations are in accordance with Practice E 527 .
1.4 Unless the order specifies the M specification designation, the material shall be furnished to the inch-pound units.
1.5 For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.
1.6 Units The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitation prior to use.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents |
| 2 | Terminology Ordering Information TABLE 1 TABLE 2 |
| 3 | TABLE 3 TABLE 4 |
| 4 | Responsibility for Quality Assurance Materials and Manufacture Chemical Composition Requirements for Castings Produced for Governmental and Military Agencies Tensile Requirements Test Specimens |
| 5 | FIG. 1 |
| 6 | Number of Tests Test Methods Retests Workmanship, Finish, and Appearance Heat Treatment Repair of Castings FIG. 2 |
| 7 | Source Inspection Foundry Inspection Identification and Repair Marking for Castings Produced for Government and Military Agencies |
| 8 | Rejection and Rehearing Certification Packaging, Marking, and Shipping Keywords A1. BASIS FOR INCLUSION OF PROPERTY LIMITS A1.1 A2. ACCEPTANCE CRITERIA FOR INCLUSION OF NEW ALUMINUM AND ALUMINUM ALLOYS IN THIS SPECIFICATION A2.1 A2.2 |
| 9 | X1. PROPERTIES AND CHARACTERISTICS X1.1 |
| 10 | X2. METRIC EQUIVALENTS X2.1 TABLE X1.1 |
