ASTM-B490 2021

$29.79

B490-09(2021) Standard Practice for Micrometer Bend Test for Ductility of Electrodeposits

Published By	Publication Date	Number of Pages
ASTM	2021	2

Guaranteed Safe Checkout

Categories: 17.040.20 - Properties of surfaces, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM B490-09-Reapproved2021

Active Standard: Standard Practice for Micrometer Bend Test for Ductility of Electrodeposits

ASTM B490

Scope

1.1 This practice describes a procedure for measuring the ductility of electrodeposited foils.2

1.2 This practice is suitable only for the evaluation of electrodeposits having low ductility.

1.3 The obtained ductility values must only be considered semi-quantitative because this test has a significant operator dependence.

1.4 This practice is best used for in-house process control where measurements are always made by the same operator. A change in ductility value can be used as an indication of possible changes in the electroplating solution.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ICS Code

ICS Number Code 17.040.20 (Properties of surfaces)

DOI: 10.1520/B0490-09R21

Additional information

Standard Title	B490-09(2021) Standard Practice for Micrometer Bend Test for Ductility of Electrodeposits
Published Code	ASTM
Publication Date	2021
Pages Count	2
ICS Codes	17.040.20 - Properties of surfaces