ASTM-B240 2007

$35.75

B240-07 Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloys in Ingot Form for Foundry and Die Castings

Published By	Publication Date	Number of Pages
ASTM	2007	4

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM B240-07

Historical Standard: Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloys in Ingot Form for Foundry and Die Castings

ASTM B240

Scope

1.1 This specification covers commercial zinc and zinc-aluminum (ZA) alloys in ingot form for remelting for the manufacture of pressure die castings, foundry castings and continuous cast bar stock as designated and specified in . Seven alloy compositions are specified, designated as follows:

1.2 Zinc alloys Z33521, Z33522, Z35530, and Z35540 are used primarily for remelting in the manufacture of pressure die castings. Zinc-aluminum alloys Z35635, Z35630, and Z35840 are used for remelting in the manufacture of both foundry and pressure die castings. Castings made from these ingots are specified in Specification B 86, Standard Specification for Zinc and Zinc-Aluminum Alloys for Foundry and Die Castings.

1.3 The values stated in inch-pound units are to be regarded as standard.

1.4 Systems of nomenclature used to designate zinc and zinc-aluminum (ZA) alloys used for casting are described in Appendix X1.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Keywords

bar stock; castings; concast; continuous cast bar stock; die castings; foundry castings; permanent mold castings; pressure die castings; prototyping; sand castings; ZA alloys; Zamak; zinc; zinc-aluminum alloys; zinc metal

ICS Code

ICS Number Code n/a

DOI: 10.1520/B0240-07

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Ordering Information Materials and Manufacturer Chemical Requirements Ingot Sizes and Shapes Sampling for Determination of Chemical Composition TABLE 1
3	Methods for Chemical Analysis Source Inspection Rejection and Rehearing Identification Marking Certification Preparation for Delivery Keywords X1. NOMENCLATURE SYSTEMS FOR ZINC AND ZINC-ALUMINUM (ZA) ALLOYS X1.1 X1.2
4	TABLE X1.1

Additional information

Standard Title	B240-07 Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloys in Ingot Form for Foundry and Die Castings
Published Code	ASTM
Publication Date	2007
Pages Count	4