ASTM-A623M 2022(Redline)

$58.50

A623M-22 Standard Specification for Tin Mill Products, General Requirements [Metric] (Redline)

Published By	Publication Date	Number of Pages
ASTM	2022

Guaranteed Safe Checkout

Categories: 77.140.50 - Flat steel products and semi-products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A623M-22

Redline Standard: Standard Specification for Tin Mill Products, General Requirements [Metric]

ASTM A623M

Scope

1.1 This specification covers a group of common requirements, which unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.

1.2 In case of conflict in requirements, the requirements of the purchase order, the individual material specification, and this general specification shall prevail in the sequence named.

Note 1: A complete inch-pound companion to Specification A623M has been developed—Specification A623; therefore, no inch-pound equivalents are presented.

1.3 The following safety hazards caveat covers Annex A1 through Annex A8 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

strength; tensile; tin mill products;

ICS Code

ICS Number Code 77.140.50 (Flat steel products and semi-products)

DOI: 10.1520/A0623M-22

Additional information

Standard Title	A623M-22 Standard Specification for Tin Mill Products, General Requirements [Metric] (Redline)
Published Code	ASTM
Publication Date	2022
ICS Codes	77.140.50 - Flat steel products and semi-products