ASTM-A518:2008 Edition

$40.63

A518/A518M-99(2008) Standard Specification for Corrosion-Resistant High-Silicon Iron Castings

Published By	Publication Date	Number of Pages
ASTM	2008	6

Guaranteed Safe Checkout

Categories: 77.140.80 - Iron and steel castings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers high-silicon cast iron castings intended for corrosion-resistant service.

1.2 This specification covers three grades as shown in Table 1. Selection of grade depends on the corrosive service to be experienced by the casting. All three grades are suited for application in severe corrosive environments. However, Grade 2 is particularly suited for application in strong chloride environments, and Grade 3 is recommended for impressed current anodes.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 The following safety hazards caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 Chemical Composition

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Ordering Information TABLE 1
2	Method of Manufacture Chemical Composition Chemical Analysis Heat Treatment Mechanical Requirements
3	Transverse Bend Test Method Workmanship, Finish, and Appearance Number of Tests and Retests Inspection Rejection and Rehearing Certification Product Marking TABLE 2
4	FIG. 1 FIG. 2
5	A1. SILICON BY THE FUSION-HYDROCHLORIC ACID DEHYDRATION METHOD A1.1 A1.2 Procedure
6	A1.3 Calculations