ASTM-A385 2009
$40.63
A385/A385M-09 Standard Practice for Providing High-Quality Zinc Coatings (Hot-Dip)
| Published By | Publication Date | Number of Pages |
| ASTM | 2009 | 9 |
1.1 This practice covers the precautions that should be taken to obtain high-quality hot-dip galvanized coatings.
1.2 Where experience on a specific product indicates a relaxing of any provision, the mutually acceptable change shall be a matter for agreement between the manufacturer and purchaser.
1.3 This specification is applicable to orders in either inch-pound units (as A 385) or in SI units (as A 385M). Inch-pound units and SI units are not necessarily exact equivalents. Within the text of this specification and where appropriate, SI units are shown in brackets. Each system shall be used independently of the other without combining values in any way.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Steel Selection |
| 2 | Assemblies of Different Materials or Different Surfaces or Both Overlapping or Contacting Surfaces FIG. 1 FIG. 2 |
| 3 | Sheet Steel Rolled Over a Wire or Rod Stiffener Weld Flux Removal and Welding Rods Flame Cut Cope Edges Preparation Cold Forming Before Galvanizing Shearing, Cutting and Punching Before Galvanizing Warpage and Distortion Design Recommendations for Providing for the Free Flow of Cleaning Solutions, Fluxes, Air, and Zinc TABLE 1 TABLE 2 FIG. 3 FIG. 4 |
| 4 | Moving Parts Marking for Identification Galvanized Steel in Concrete FIG. 5 FIG. 6 |
| 5 | Galvanized Nuts, Bolts, and Tapped Holes in Galvanized Products FIG. 7 FIG. 8 |
| 6 | Critical Dimensions Keywords FIG. 9 |
| 7 | FIG. 10 |
| 8 | FIG. 11 FIG. 12 |
